 |
| More information on the 2810 model |
  |
Pre-cooling |
| Some samples are easily
deactivated at normal temperature. In such cases, pre-cooling
enables the samples to reach a low temperature before
the experiment, thus avoiding deactivation of valuable
samples. |
|
Memory flashing function (Patent pending) |
| The memory flashing
function makes the spin-down easy and simple by storing
previous spinning time automatically, then recalling
repeatedly. Pressing the flashing key, same operation
whose spinning time is from 1 second to 90 seconds
can be repeated. |
|
Three channel memory settings |
| The memory setting function
makes routine work easy and simple, storing centrifugal
speed, RCF and time. It is possible to save, recall
and operate the centrifugal condition just by pushing
the program switches. |
|
Tachometer-port |
| The 2810 has a tachometer-port
on its lid to check the actual speed. The validation of
the speed sensor by measuring the actual speed is highly
needed for stringent GMP requirements. |
|
Five types of notification sounds |
The notification sound
can be selected from one buzzer and 4 melodies. This will
be useful to identify each unit when several units are
used in the same room.
And also, mute setting is available. |
|
Acceleration/Deceleration (Two-level switching) |
| The 2810 model provides
two-level switching for both acceleration and deceleration,
corresponding to application requirements. For example,
in those cases where one must avoid whirring up the samples,
a slow deceleration can be programmed so as to achieve
the desired conditions and most accurate results. |
|
Digital display and control knob |
| The control knob and
digital display provide users with an easy-to-operate
interface. The control knob is much easier to set than
up-down-keys, and the degital display clearly indicates
each parametier. |
|
Indication of the correct RCF value |
| Actual rotation radius
can be set and indication of correct RCF is realized. |
|
Balancing of the sample |
| The 2810 model enables
one to reduce the experiment time, allowing centrifugal
separation to be carried out with eye measured sample
balancing. With its tolerable inbalance sensor, it is
not necessary to balance the sample with remarkable accuracy.
In addition, the operation is smooth and it maintains
a quiet environment. |
|
 TOP |
